The use of permeable piles as an effective drainage method in liquefiable sites has become widely accepted. In this study, the seismic response of both the liquefiable soil and the pile was simulated using FLAC3D software to validate the anti-liquefaction performance of the permeable pile. A group of permeable piles designed according to the China foundation code were numerically modeled with various opening ratios (i.e. area of openings/total surficial area). The numerical results showed that the permeable pile is able to enhance liquefaction resistance by dissipating excess pore water through the drainage holes. The bending moments and axial force of the permeable pile decrease but the ultimate bearing capacity increases in the process of drainage. It is found that the excess pore water pressure ratio (EPWPR) of soil around permeable pile under seismic loading reduces rapidly with increasing opening ratio, but the excess pore water pressure tends to keep nearly a stable level once the opening ratio is beyond a critical value of 0.5%. As a result, the critical value of the opening ratio may be considered as the optimum parameter to design the permeable pile against liquefaction.

Owing to the high strength and abrasive characteristics of cobble-boulders, cutters are easily worn and damaged during shield tunneling, making construction inefficient. In the present work, the stress on the ripper and scraper on the cutterhead was analyzed by the PFC3D-FLAC3D coupling model of shield tunneling to get insight into the performance of the cutterhead for cutting underground cobble and boulders. The numerical calculation results revealed that the increase in trajectory radius leads to a rising stress on the cutters, and the stress on the front cutting surface is greater than that on the back of the cutters. Moreover, the correlation between cutter wear and stress is revealed based on field measurement data. The distribution of the cutter stress is consistent with the cutter wear and breakage characteristics in actual construction, in which more extensive cutter stress is exhibited, extreme cutter wear appears, and more cutter breakage occurs. Finally, the relationship between the cutterhead opening area's layout and cutter wear distribution was investigated, indicating that the cutter wear extent is the most severe in the region where the radial opening ratio dropped sharply.