One of the prerequisites for the safe exploitation of surface mines is the stability of the working and final slopes of the mine. In order to ensure this, it is necessary to carry out detailed field and laboratory geomechanical tests of the soil and, based on the obtained results, make calculations related to stability analyses. The results obtained in this way are used for dimensioning the slope of exploitation slopes (excavation). Landslides occur when the ultimate shear strength is reached, and therefore, the adequate definition of shear strength parameters is one of the essential prerequisites for successfully solving the stability problem. Unlike earlier tests in Serbia, when the residual shear strength parameters were determined based on the usual conventional methods (direct shear apparatus, triaxial apparatus), this time, in addition to the direct shear apparatus, a ring shear apparatus was also chosen for testing. The paper shows the method of determining the residual shear strength parameters of high plasticity gray clays and siltstones of roof sediments from open pit mine Drmno, using direct and ring shear apparatus. The results show that the residual angle of internal friction for gray clays obtained with the ring shear apparatus is 9.9-10.8 degrees, and for the siltstone, it is 11.8-12.9 degrees, both of which are lower than the values obtained with the direct shear apparatus. In addition, correlations between the residual parameters of soil shear resistance and some physical indicators (plasticity index, clay content) are provided, showing high correlation coefficients. The proposed correlations should be used only when time and financial constraints prevent the execution of actual tests to determine residual shear strength, as concrete experimental procedures provide a much more reliable assessment of the residual strength properties of the soil.

Understanding direction-dependent friction anisotropy is necessary to optimize interface shear resistance across soil-structure. Previous studies estimated interface frictional anisotropy quantitatively using contractive sands. However, no studies have explored how sand with a high dilative tendency around the structural surface affects the interface shear response. In this study, a series of interface direct shear tests are conducted with selected French standard sand and snakeskin-inspired surfaces under three vertical stresses (50, 100, and 200 kPa) and two shearing directions (cranial -> caudal or caudal -> cranial). First, the sand-sand test observes a higher dilative response, and a significant difference between the peak and residual friction angles (phi peak - phi res = 8 degrees) is obtained at even a lower initial relative density Dr = 40%. In addition, the interface test results show that (1) shearing against the scales (cranial shearing) mobilizes a larger shear resistance and produces a dilative response than shearing along the scales (caudal shearing), (2) a higher scale height or shorter scale length exhibits a higher dilative tendency and produces a higher interface friction angle, and (3) the interface anisotropy response is more pronounced during cranial shearing in all cases. Further analysis reveals that the interface friction angle and dilation angle are decreased with the scale geometry ratio (L/H). For L/H values between 16.67 and 60, the interface dilation angle varies between 9 degrees and 4 degrees for cranial first shearing and 3.9 degrees-2.6 degrees for caudal first shearing. However, the difference in dilation angle within the same shearing direction is less than 1 degrees.