Granite residual soil is widely used as a subgrade filler in highway construction. Dynamic loads induced by vehicles and earthquakes are complex and involve multidirectional loads, and the dynamic behavior of soil under multidirectional cyclic loading differs significantly from that under unidirectional cyclic loading. A series of horizontal cyclic direct shear tests under cyclic normal loading were conducted using a large-scale cyclic direct shear apparatus at different shear displacement amplitudes (1, 3, 6, and 9 mm) and normal stress amplitudes (0, 100, and 200 kPa). The test results indicate that under cyclic normal stress, the dynamic shear strength of granite residual soil increased during the forward shear process but decreased during the reverse shear process. The damping ratio increases with increasing shear displacement amplitude and normal stress amplitude. This behavior is associated with higher excess pore water pressure induced by greater normal stress amplitude and larger shear displacement, which drive the soil into the yielding phase. The Granite residual soil exhibited significant asymmetric hysteretic characteristics under bidirectional dynamic loading. However, no model has yet been found to describe the asymmetric hysteretic behavior of soil under bidirectional dynamic loading. To obtain the asymmetric hysteretic curve of granite residual soil under bidirectional cyclic loading conditions in the laboratory without the instruments for bidirectional cyclic direct shear tests, the Hardin-Drnevich model and the second Masing rule were extended to propose two asymmetric hysteretic curve models under bidirectional cyclic loading based on the tests. Both models fit with the test results well.

The shear strength deterioration of bedding planes between different rock types induced by cyclic loading is vital to reasonably evaluate the stability of soft and hard interbedded bedding rock slopes under earthquake; however, rare work has been devoted to this subject due to lack of attention. In this study, experimental investigations on shear strength weakening of discontinuities with different joint wall material (DDJM) under cyclic loading were conducted by taking the interface between siltstone and mudstone in the Shaba slope of Yunnan Province, China as research objects. A total of 99 pairs of similar material samples of DDJM (81 pairs) and discontinuities with identical joint wall material (DIJM) (18 pairs) were fabricated by inserting plates, engraved with typical surface morphology obtained by performing three-dimensional laser scanning on natural DDJMs sampled from field, into mold boxes. Cyclic shear tests were conducted on these samples to study their shear strength changes with the cyclic number considering the effects of normal stress, joint surface morphology, shear displacement amplitude and shear rate. The results indicate that the shear stress vs. shear displacement curves under each shear cycle and the peak shear strength vs. cyclic number curves of the studied DDJMs are between those of DIJMs with siltstone and mudstone, while closer to those of DIJMs with mudstone. The peak shear strengths of DDJMs exhibit an initial rapid decline followed by a gradual decrease with the cyclic number and the decrease rate varies from 6% to 55.9% for samples with varied surface morphology under different testing conditions. The normal stress, joint surface morphology, shear displacement amplitude and shear rate collectively influence the shear strength deterioration of DDJM under cyclic shear loading, with the degree of influence being greater for larger normal stress, rougher surface morphology, larger shear displacement amplitude and faster shear rate. (c) 2024 Institute of Rock and Soil Mechanics, Chinese Academy of Sciences. Production and hosting by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/ licenses/by-nc-nd/4.0/).