The increasing demand for sustainable road infrastructure necessitates alternative materials that enhance soil stabilization while reducing environmental impact. This study investigated the application of organosilane-based nanotechnology to improve the structural performance and durability of road corridors in Peru, offering a viable alternative to conventional stabilization methods. A comparative experimental approach was employed, where modified soil and asphalt mixtures were evaluated against control samples without nanotechnology. Laboratory tests showed that organosilane-treated soil achieved up to a 100% increase in the California Bearing Ratio (CBR), while maintaining expansion below 0.5%, significantly reducing moisture susceptibility compared to untreated soil. Asphalt mixtures incorporating nanotechnology-based adhesion enhancers exhibited a Tensile Strength Ratio (TSR) exceeding 80%, ensuring a superior resistance to moisture-induced damage relative to conventional mixtures. Non-destructive evaluations, including Dynamic Cone Penetrometer (DCP) and Pavement Condition Index (PCI) tests, confirmed the improved long-term durability and load-bearing capacity. Furthermore, statistical analysis of the International Roughness Index (IRI) revealed a mean value of 2.449 m/km, which is well below the Peruvian regulatory threshold of 3.5 m/km, demonstrating a significant improvement over untreated pavements. Furthermore, a comparative reference to IRI standards from other countries contextualized these results. This research underscores the potential of nanotechnology to enhance pavement resilience, optimize resource utilization, and advance sustainable construction practices.

The road sector is actively exploring strategies to reduce greenhouse gas emissions by investigating the potential use of local and recycled materials, including quarry waste sand. This study presents the results of frost heave and repeated load triaxial tests conducted on fully characterized Norwegian quarry waste sands. The tests examined the effects of two nontraditional additives, lignosulfonate and organosilane, on the engineering properties of the quarry waste sands. Thermal conductivity tests were also performed on untreated samples. The quarry waste sands, including gneiss, gabbro, quartz-diorite, limestone, and granite, exhibited varying fine contents ranging from 7% to 28%. A thermal conductivity model was validated with R2 values ranging from 0.87 to 0.99. The frost susceptibility was found to be reduced by 65% in samples treated with 1% additive content, and further improvements of 85% at a 2% concentration. Moreover, the addition of 1.5% lignosulfonate or 0.5% organosilane significantly improved the resilient modulus, elastic stiffness, and resistance to permanent deformation in all samples. These findings highlight the improved frost protection and mechanical properties of the stabilized quarry waste sands, contributing to enhanced pavement stability and longevity. Furthermore, incorporating lignosulfonate additives in quarry waste sands offers a promising solution for environmentally sustainable road construction. Further research, including comprehensive field-testing and life-cycle cost analyses, is recommended to assess the economic, technical, and environmental aspects of these additives.