Copper (Cu) holds a significant importance in plant metabolism as it serves as an essential micronutrient but becomes toxic at higher concentrations. Nitric oxide (NO), a key signaling molecule, and nitrogen (N) play essential roles in combating toxicity of some metals. This study explores the potential of interactive effects of NO as 100 mu M SNP (sodium nitroprusside, NO source) and N (80 mg N kg-1 soil) in mitigating Cu (100 mg Cu kg-1 soil) stress in mustard (Brassica juncea L.) plants. The impaired physio-biochemical changes, photosynthetic efficiency, and the expression level of genes associated with photosynthesis, and N assimilation under Cu stress were ameliorated with the exogenous application of NO and N. The combined treatment of NO and N conspicuously lowered reactive oxygen species (ROS) and its related impacts. It also enhanced the activity and relative expression of antioxidant enzymes, including ascorbate peroxidase (APX), glutathione reductase (GR), and superoxide dismutase (SOD) as well as N assimilation enzymes, such as nitrate reductase (NR) and nitrite reductase (NiR). The supplementation of NO and N also triggered the expression of rbcL (large subunit of Rubisco), photosystem (photosystem II D1 protein; psbA and photosystem II protein B; psbB) and markedly improved photosynthetic capacity under Cu stress. The study highlights the significance of NO and N as a potential strategy to counteract Cu-induced stress in crops. It suggests a synergistic or interactive effect between the two substances as a phytoremediation strategy for enhancing crop growth and productivity in Cu-contaminated soils. Understanding the mechanisms behind NO and N mediated stress alleviation could facilitate the development of targeted approaches to enhance plant resilience against heavy metal stress.

Stem mustard, the main raw material for pickled mustard tuber, is widely planted in Chongqing, China, and is an important local cash crop. Under the working conditions of sticky and wet soil in the Chongqing area, conventional furrow seeding has problems such as soil sticking to the furrow opener, poor mulching effect, etc. In this regard, this paper proposes the use of non-contact, soil-based, pneumatic shot seeding, in which seeds are shot into the soil to a predetermined depth by a high-speed air stream. The diameter of stem mustard seeds was found to be 1.33 mm, with a spherical rate of 95.32% using physical and mechanical properties. The high-speed camera test was used to determine the air pressure at the appropriate sowing depth, and the seed entry process was simulated by EDEM 2021 software, which analysed the movement process of the seed after entering the soil, and the structure of the seeder was designed based on the resulting test data. The structural parameters of the shot seeding device were analysed by a hydrodynamic simulation using Fluent 2022 R1 software and the following results were obtained: an outlet pipe diameter DC of 2 mm, mixing zone length H of 10 mm, mixing zone inlet diameter D of 15 mm, and steady-state gas flow rate of 80 m/s. Simulation seeding verification was conducted on the final determined structural parameters of the seeding device, and the simulation results showed that the seed velocity could reach 32.3 m/s. In actual experiments, it was found that when the vertical velocity of the seeds was greater than or equal to 26.59 m/s, the seeds could be completely and stably seeded into the soil. Therefore, the designed seeding device can meet the conditions of actual seeding experiments. In conclusion, this research offers a practical guideline for the rapid and precise sowing of stem mustard.

This study synthesized and modified a semi-interpenetrating polymer network hydrogel from polyacrylamide, N,N '-dimethylacrylamide, and maleic acid in a potassium hydroxide solution. The chemical composition, interior morphology, thermal properties, mechanical characteristics, and swelling behaviors of the initial hydrogel (SH) and modified hydrogel (SB) in water, salt solutions, and buffer solutions were investigated. Hydrogels were used as phosphate fertilizer (PF) carriers and applied in farming techniques by evaluating their impact on soil properties and the growth of mustard greens. Fourier-transform infrared spectra confirmed the chemical composition of SH, SB, and PF-adsorbed hydrogels. Scanning electron microscopy images revealed that modification increased the largest pore size from 817 to 1513 mu m for SH and SB hydrogels, respectively. After modification, the hydrogels had positive changes in the swelling ratio, swelling kinetics, thermal properties, mechanical and rheological properties, PF absorption, and PF release. The modification also increased the maximum amount of PF loaded into the hydrogel from 710.8 mg/g to 770.9 mg/g, while the maximum % release of PF slightly increased from 84.42% to 85.80%. In addition, to evaluate the PF release mechanism and the factors that influence this process, four kinetic models were applied to confirm the best-fit model, which included zero-order, first-order, Higuchi, and Korsmeyer-Peppas. In addition, after six cycles of absorption and release in the soil, the hydrogels retained their original shapes, causing no alkalinization or acidification. At the same time, the moisture content was higher as SB was used. Finally, modifying the hydrogel increased the mustard greens' lifespan from 20 to 32 days. These results showed the potential applications of modified semi-IPN hydrogel materials in cultivation.