Geocells are three-dimensional, interconnected cellular geosynthetics widely used to enhance the overall strength of soils. Their foldable structure can cause variations in pocket shape during installation, depending on the extent of extension. Understanding the impact of these shape variations is essential for optimizing reinforcement efficiency and reducing the associated geocell application costs. The aspect ratio, defined as the ratio of the cell's transverse (welded) axis to the longitudinal (wall summit) axis, is proposed to evaluate the degree of extension of the most commonly utilized honeycomb-shaped geocell. A coupled continuum-discontinuum numerical method was employed to investigate the behavior of honeycomb-shaped geocell reinforced soils across various aspect ratios under confined compressive loading. The simulation results indicate that a geocell with an aspect ratio of 1.0 exhibits optimal reinforcement efficiency, and whereas reinforcement efficiency decreases as the aspect ratio deviates from 1.0 causing pocket geometries to flatten. The superior performance of rounded geocells is attributed to their enhanced ability to promote load-bearing in strong contact subnetworks. This results in denser packing structures, higher contact force anisotropy from a microscopic perspective, and greater confinement capacity against deformation from a macroscopic perspective.

The protection of the ecological environment and the scarcity of renewable resources are increasingly concerning global issues. To address these challenges, efforts have been made to use desert sand and fly ash in the preparation of building materials. This study attempts to replace river sand with desert sand and cement with fly ash to create an environmentally friendly and economical building material-desert sand dry-mixed mortar (DSDM). Through preliminary mix ratio experiments, five grades of DSDM were developed, and their durability in the saline soil regions of northwest China was studied. The study conducted macro-performance tests on the five strength grades of DSDM after sulfate dry-wet cycles (DWCs), analyzing changes in appearance, mass loss rate, compressive strength loss rate, and flexural strength loss rate. Using SEM, XRD, and NMR testing methods, the degradation mechanisms of the DSDM samples were analyzed. Results indicate that sulfate ions react with hydration products to form ettringite and gypsum, leading to sulfate crystallization. In the initial stages of DWCs, these erosion products fill the pores, increasing density and positively impacting the mortar's performance. However, as the number of cycles increases, excessive accumulation of erosion products leads to further expansion of pores and cracks within the DSDM, increasing the proportion of harmful and more harmful pores, degrading performance, and ultimately causing erosion damage to the mortar. Among the samples, DM5 exhibited the poorest erosion resistance, fracturing after 30 cycles with a mass loss of 43.57%. DM10 experienced failure after 60 cycles, with its compressive strength retention dropping to 78.86%. In contrast, DM15, DM20, and DM25 showed the best erosion resistance, with compressive strength retention above 75% after 120 cycles. Finally, the Wiener random probability distribution was used to predict the remaining life of DSDM samples under different degradation indicators, with flexural strength being the most sensitive indicator. Based on the flexural strength loss rate, the maximum sulfate DWCs for DM5, DM10, DM15, DM20, and DM25 were 132, 118, 78, 52, and 35 cycles, respectively. This study provides a theoretical basis for the promotion and use of DSDM in desert fringe areas.